Specifications (LED strip) * LED Quantity/Type: 150xSMD5050 RGB * Input Voltage (to power supply): 100-240VAC, 50/60Hz * Power: 36W * LED Strip Width: 10mm * LED Strip Length: 16.4ft (5m) * IP Rating: IP30 (dry locations only) Items Included * (1x) RGB LED strip with adhesive back * (1x) Controller and 44-button wireless IR remote * (1x) Power supply Wiring * Unroll LED strip completely. * Any exposed wires on the other end of the LED strip must not touch one another (or any metal object), creating a short. * Connect the 4-pin connector of controller to that of the LED strip, making sure that the arrows line up. * Connect 5mm DC jack of power supply to controller. * Remove the plastic seal in the battery compartment of the wireless remote. * Double check that all connections are correct and secure, then plug in power cord. Note * While the included controller can handle the power requirement of two such strips, the power supply only has the capacity to drive a single strip. * Do not lengthen the LED strip by directly connecting an additional section to it. * Extension kits are available for adding additional strips. * Test all components before permanent installation. * Make sure that wires at the other end of the LED strip are not touching one another (or any metal object), which would create a short circuit. Electrical tape may be used to wrap each of those wire ends to isolate them. * The LED strip is cuttable every 3 LEDs, approx. every 4″, at the designated cut marks.
Complete kit includes: flexible LED strip, controller with wireless IR remote, and power supply
Set static colors, adjust brightness, select various auto color-changing modes via wireless IR remote
LED strip is cuttable and linkable to fit various length requirements (required components not included, combined length should not exceed 16ft)
Flexible – fits just about any space one can imagine
Eco friendly – uses very little energy, without harmful radiations